Bare-Co PTO driveline parts
PTO Shaft Safety Guards and Guard Parts
Universal replacement guards that fit almost any PTO shaft, cut to length, with all standard bearings included. Plus special bearing sets for BYPY square tube and large Walterscheid shafts, and extension bellows.
Pick the guard by the yoke bearing groove. Small guards fit grooves of 1 5/16″ to 2 1/8″ (shafts up to series 4). Large guards fit 2″ to 3 1/8″ (series 6 and up). Measure the groove on the yoke where the guard bearing sits.
What’s included
Each guard is complete: both guard halves, the cones and all standard guard bearings. Cut both tubes to your shaft’s length with a fine saw.
Special bearings
BYPY shafts with a square drive tube and very large Walterscheid shafts need the special bearing set listed with each guard. Standard bearings are on the guard bearing page.
Extension bellows
Fit an extension bellow where the guard has to cover to the end of the end yoke. AS2E fits small guards, AS3E large guards.
Fitment as listed by Bare-Co. Confirm your shaft series and yoke bearing groove diameter before ordering.