Warning: Wide-angle joints are rated for 80° (75° for P675 Series) only for short-term operation or when stationary, and 25° for continuous operation.
Going past the maximum angle will make the joint ball and socket fail, which is not covered by warranty. Fit a tractor turning limiter to the implement drawbar.
Measure from the center of the tractor-end cross to the center of the inner cross at the implement end. HP and length are optional. Matching shafts are highlighted in every section.
Section 1
Standard Wide-Angle Shaft
1 3/8″ × 6 Spline Quick-Release Yokes at Both Ends
Wide-Angle Joint at Tractor End
Every shaft in this section has this yoke configuration.
Section 2
Wide-Angle Joint at Both Ends
Wide-Angle Joints at Both Ends
1 3/8″ × 6 Spline Quick-Release Yokes at Both Ends
Every shaft in this section has this configuration.
Section 3
Shaft With One Standard Yoke
1 3/8″ × 6 Spline Quick-Release Wide-Angle Yoke at Tractor End
NO End Yoke on the Plain End
The plain end will accept a non-standard yoke (sold separately).
Section 4
Wide Angle With Clutch
8″ (200 mm) Clutch on the Plain End
Tractor-end yoke and clutch spline are listed for each shaft.
Section 5
Wide Angle With Shear Bolt Yoke
1 3/8″ × 6 Spline Quick-Release Yoke at Tractor End
Shear Bolt Yoke on the Plain End
Shear bolt yoke spline is listed for each shaft.
Section 6
Wide Angle With Clamp Yoke
1 3/8″ × 6 Spline Quick-Release Yoke at Tractor End
Clamp Yoke at Implement End
Implement-end spline is listed for each shaft.
Section 7
Shaft With 21 Spline Tractor Yoke
1 3/8″ × 21 Spline Quick-Release Yoke at Tractor End
Implement-end yoke is listed for each shaft.
Section 8
Shaft With 20 Spline Tractor Yoke
1 3/4″ × 20 Spline Quick-Release Yoke at Tractor End
Implement-end yoke is listed for each shaft.
Section 9
Wide-Angle Half Shafts
Wide-Angle Half Tractor End (Inner Tube)
+ Plain-End Half Implement End (Outer Tube)
Mix and match one tractor-end half with one implement-end half of the same series. Half shafts can be trimmed for custom lengths.
Lengths are closed – open working ranges. Spare parts: WB series see Bare-Co page PTO 31, WW series see page PTO 43. Confirm HP rating, spline and yoke type before ordering.
