Measure from the center of the tractor-end cross to the center of the implement-end cross. HP and length are optional. Matching shafts are highlighted in every section.
Section 1
Standard Shaft
1 3/8″ × 6 Spline Quick-Release Yokes at Both Ends
Every shaft in this section has this yoke configuration.
Section 2
Shaft With One Standard Yoke
1 3/8″ × 6 Spline Quick-Release Yoke at One End
NO End Yoke on the Other End
The plain end will accept a non-standard yoke (sold separately).
Section 3
Shaft With No End Yokes
NO End Yokes on Either End
Both plain ends will accept non-standard yokes (sold separately).
Section 4
Shear Bolt Shaft
Round Bore Shear Pin Yoke at One End
1 3/8″ × 6 Spline Quick-Release Yoke at Other End
Round bore diameter is listed for each shaft.
Section 5
Heavy-Duty Shaft With Clamp Yoke
1 3/8″ × 6 Spline Quick-Release Yoke at Tractor End
Clamp Yoke at Implement End
Implement-end spline is listed for each shaft.
Section 6
Shaft With 21 Spline Tractor Yoke
1 3/8″ × 21 Spline Quick-Release Yoke at Tractor End
Implement-end yoke is listed for each shaft.
Section 7
Shaft With 20 Spline Tractor Yoke
1 3/4″ × 20 Spline Quick-Release Yoke at Tractor End
Implement-end yoke is listed for each shaft.
Section 8
Shaft With 20 Spline Clamp Yoke
1 3/4″ × 20 Spline Clamp Yoke at One End
NO End Yoke on the Other End
The plain end will accept a non-standard yoke (sold separately).
Lengths are approximate working ranges (collapsed – extended). Confirm HP rating, spline and yoke type before ordering.
Product Question
✕
Join WaitlistWe will inform you when the product arrives in stock. Please leave your valid email address below.
