100 HP CV Shaft with 1 3/8" 6 Splines at Both Ends Length: 77" - 116" – Part # WB8150
100 HP CV Shaft with 1 3/8" 6 Splines at Both Ends Length: 77" - 116" – Part # WB8150 100 HP CV Shaft with 1 3/8" 6 Splines at Both Ends Length: 60" - 85" $1,144.99
100 HP CV Shaft with 1 3/8" 6 Splines at Both Ends Length: 77" - 116" – Part # WB8150 100 HP CV Shaft with 1 3/8" 6 Splines at Tractor End with no Implement Yoke Length: 60" - 85" $1,193.99
100 HP

100 HP CV Shaft with 1 3/8″ 6 Splines at Both Ends Length: 77″ – 116″

Part No. WB8150 · Overall length 75″ – 116″

$1,193.99

Cross to cross
63″ – 102″
Overall
75″ – 116″
Both yokes
1 3/8″ 6 Quick Connect

Units Sold: 3

Questions about this part? We're here to help.

Send us your part number or a photo and we'll make sure you get the right fit.

Text us: 346-465-2689 Email us

Specifications

100 HP CV Shaft with 1 3/8" 6 Splines at Both Ends Length: 77" - 116" specifications
Part numberWB8150
Mfg.Bare-co
Overall Length75″ – 116″
Cross to Cross63″ – 102″
Tractor Yoke1 3/8″ 6 Quick Connect
Implement Yoke1 3/8″ 6 Quick Connect
SeriesWB8
HP160 @ 1000 RPM
Safety ShieldYes
Shipping weight106 lbs
Box size80 × 12 × 12 in

Will it fit?

  1. Hook up the implement and set it at its shortest working position.
  2. Measure from the center of the tractor-end cross to the center of the implement-end cross.
  3. Your measurement must fall inside 63″ – 102″ for this shaft.
Not the right length? Use the PTO shaft selector

About this part

WARNING

80 degree (75 degree for P675 Series) Short Term Operation and Stationary.
25 degree Continuous Operation
Exceeding maximum angle will result in joint ball / socket FAILURE!
(NOT COVERED BY WARRANTY)
Tractor turning limiter should be fitted to the implement drawbar.

Related products