100 HP CV Shaft with 1 3/8" 6 Splines at Tractor End with no Implement Yoke Length: 60" - 85" – Part # WE8105
100 HP CV Shaft with 1 3/8" 6 Splines at Tractor End with no Implement Yoke Length: 60" - 85" – Part # WE8105 100 HP CV Shaft with 1 3/8" 6 Splines at Both Ends Length: 77" - 116" $1,193.99
WC61502121 WC6150 64 HP CV Shaft with Clutch 1 3/8" 21 Splines at Both Ends Length: 75" - 114" $989.99
100 HP

100 HP CV Shaft with 1 3/8″ 6 Splines at Tractor End with no Implement Yoke Length: 60″ – 85″

Part No. WE8105 · Overall length 60″ – 85″

Series 8 CV Joint PTO Shaft

Wide Angle Shaft

See Warning Below.

$1,193.99

Mfg.
Bare-co
Overall Length
60″ – 85″
Cross to Cross
45″ – 71″
Tractor Yoke
1 3/8″ 6 Quick Connect
Implement Yoke
None
Series
WB8
HP
100 @ 540 RPM / 160 @ 1000 RPM
Safety Shield
Yes

Questions about this part? We're here to help.

Send us your part number or a photo and we'll make sure you get the right fit.

Text us: 346-465-2689 Email us
Recently Viewed Products

Specifications

100 HP CV Shaft with 1 3/8" 6 Splines at Tractor End with no Implement Yoke Length: 60" - 85" specifications
Part numberWE8105
Mfg.Bare-co
Overall Length60″ – 85″
Cross to Cross45″ – 71″
Tractor Yoke1 3/8″ 6 Quick Connect
Implement YokeNone
SeriesWB8
HP100 @ 540 RPM / 160 @ 1000 RPM
Safety ShieldYes
Shipping weight75 lbs
Box size70 × 12 × 12 in

Will it fit?

  1. Hook up the implement and set it at its shortest working position.
  2. Measure from the center of the tractor-end cross to the center of the implement-end cross.
  3. Your measurement must fall inside 45″ – 71″ for this shaft.
Not the right length? Use the PTO shaft selector

About this part

WARNING

80 degree (75 degree for P675 Series) Short Term Operation and Stationary.
25 degree Continuous Operation
Exceeding maximum angle will result in joint ball / socket FAILURE!
(NOT COVERED BY WARRANTY)
Tractor turning limiter should be fitted to the implement drawbar.

Related products