100 HP Series 8 CV Joint Shaft, 1 3/4″ 20 Splines Tractor Yoke, Implement Side Cross Only, Length: 77″ – 116″ – Part # WE815020
100 HP Series 8 CV Joint Shaft, 1 3/4″ 20 Splines Tractor Yoke, Implement Side Cross Only, Length: 77″ – 116″ – Part # WE815020 64 HP Series 6 CV Joint Shaft with Shear Bolt Yoke, 1 3/8″ 21 Splines Tractor Yoke, 1 3/8″ 6 Splines Shear Bolt Yoke, Length: 75″ – 114″ $975.99
CV Shaft

100 HP Series 8 CV Joint Shaft, 1 3/4″ 20 Splines Tractor Yoke, Implement Side Cross Only, Length: 77″ – 116″

Part No. WE815020 · Overall length 77″ – 116″

Series 8 CV Joint PTO Shaft

Wide Angle Shaft

See Warning

80 degree (75 degree for P675 Series) Short Term Operation and Stationary.
25 degree Continuous Operation
Exceeding maximum angle will result in joint ball / socket FAILURE!
(NOT COVERED BY WARRANTY)
Tractor turning limiter should be fitted to the implement drawbar.

$1,143.99

Mfg.
Bare-co
Overall Length
77″ – 116″
Cross to Cross
63″ – 102″
Tractor Yoke
1 3/4″ 20 Quick Connect
Implement Side
Cross Only
Series
WB8
HP
100 @ 540 RPM / 160 @ 1000 RPM
Safety Shield
Yes

Questions about this part? We're here to help.

Send us your part number or a photo and we'll make sure you get the right fit.

Text us: 346-465-2689 Email us
⚠ WARNING: Rotating drivelines can cause serious injury or death. Keep all guards and shields in place, shut off the engine and remove the key before working on the driveline, and use a part rated for your tractor and implement.
⚠ WARNING (California): This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

Specifications

100 HP Series 8 CV Joint Shaft, 1 3/4″ 20 Splines Tractor Yoke, Implement Side Cross Only, Length: 77″ – 116″ specifications
Part numberWE815020
Mfg.Bare-co
Overall Length77″ – 116″
Cross to Cross63″ – 102″
Tractor Yoke1 3/4″ 20 Quick Connect
Implement SideCross Only
SeriesWB8
HP100 @ 540 RPM / 160 @ 1000 RPM
Safety ShieldYes
Shipping weight78.5 lbs
Box size82 × 12 × 12 in

Will it fit?

  1. Hook up the implement and set it at its shortest working position.
  2. Measure from the center of the tractor-end cross to the center of the implement-end cross.
  3. Your measurement must fall inside 63″ – 102″ for this shaft.
Not the right length? Use the PTO shaft selector

Related products